Solution
Switching the Connection Method to Wireless LANSetting the Machine Using WPS (Push Button Mode)
Checking the Wireless LAN Setting is Completed
Switching the Connection Method to Wireless LAN
1. Press [ ] (Menu).
2. Press [ ] or [ ] to select ⋖Network Settings⋗, and then press [OK].
When the system manager PIN is specified
Enter the system manager PIN.
When you are finished entering, press [ ] or [ ] to select ⋖Apply⋗, and then press [OK].
The next screen is displayed for approximately 5 seconds.
Turn OFF/ON using Step 5. Turning this OFF/ON is not required.
3. Press [ ] or [ ] to select ⋖Select Wired/Wireless LAN⋗, and then press [OK].
4. Press [ ] or [ ] to select ⋖Wireless LAN⋗, and then press [OK].
5. Turns the machine OFF/ON when the following screen disappears.
It is necessary to turn the machine OFF/ON to activate the settings.
Turn OFF the machine and wait for at least 10 seconds before turning it back ON.
Setting the Machine Using WPS (Push Button Mode)
1. Press [ ] (Menu).
2. Press [ ] or [ ] to select ⋖Network Settings⋗, and then press [OK].
When the system manager PIN is specified
Enter the system manager PIN.
When you are finished entering, press [ ] or [ ] to select ⋖Apply⋗, and then press [OK].
3. Press [ ] or [ ] to select ⋖Wireless LAN Settings⋗, and then press [OK].
4. Press [OK].
5. Press [ ] or [ ] to select ⋖WPS Push Button Mode⋗, and then press [OK].
6. Press [ ] to select ⋖Yes⋗, and press [OK].
7. Within 2 minutes, press and hold the WPS button on the wireless LAN router and/or access point for approximately 5 seconds.
* If ⋖Cannot find access point.⋗ appears, press [OK] to close the screen, and follow the procedure from Step 5.
8. Make sure the Wi-Fi indicator blinks.
When the wireless LAN router or access point is detected, the Wi-Fi indicator blinks.
The next screen is displayed for approximately 2 seconds, and then the Wi-Fi indicator lights.
* If an error message appears, press [OK] to close the screen, and repeat starting from Step 5.
If you cannot connect the access point after retrying, see the following:
see the "e-Manual" (HTML manual) in the CD-ROM supplied with the machine.
9. Wait until the machine sets the IP address automatically (approx. 2 min).
If you want to set the IP address manually, see the following.
Checking the Wireless LAN Setting is Completed
1. Press [ ] (Status Monitor/Cancel).
2. Select ⋖Network Information⋗ with [ ] and [ ], and then press [OK].
3. Select ⋖IPv4⋗ with [ ] and [ ], and then press [OK].
4. Select ⋖IP Address⋗ with [ ] and [ ], and then press [OK].
5. Take note of the IP address.
6. Press [ ] (Status Monitor/Cancel) to close the screen.
7. Start the web browser of a computer which is connected to a network.
8. Enter http://⋖IP address of the machine⋗/ in the address field, and then press the [ENTER] key on your keyboard. The ⋖IP address of the machine⋗ is the address noted in step 5 above.
9. Check that the screen of the Remote UI is displayed.
Caution
When the Remote UI is not displayed