imagePROGRAF iPF6100 Support
Drivers & downloads

Firmware Update Tool Ver.25.02 (Mac)

Content Id: 0400539202


Description



Outline

You can use this program to update the printer firmware version.

Update History

[Ver.25.02]
- macOS Big Sur (11.0) has been added as a supported OS.
- macOS Catalina (10.15) has been added as a supported OS.
- The limit for previous version of supported OS is changed.
v10.8.5 → v10.9.5

[Ver.25.01b]
- macOS Mojave (10.14) has been added as a supported OS.
- macOS High Sierra (10.13) has been added as a supported OS.

[Ver.25.01a]
- Correction of Mis-description in Readme.

[Ver.25.01]
- macOS Sierra (v10.12) has been added as a supported OS.

System requirements

Use this program with the systems and the operating environments below.

Software:
macOS Big Sur 11.0
macOS Catalina 10.15
macOS Mojave 10.14
macOS High Sierra 10.13
macOS Sierra v10.12
OS X El Capitan v10.11
OS X Yosemite v10.10
OS X Mavericks v10.9

The supported OS conforms to the system requirements of the product.

Hardware:
Any computer running the software listed above.

Compatible Printers:
Canon imagePROGRAF series

Setup Instructions

1.Switch the printer on.
2.When you have downloaded the file, decompress it on your computer hard disk.
3.Execute the iPFFirmwareUpdateTool.pkg file.
The imagePROGRAF Firmware Update Tool is installed.
4.Execute the installed imagePROGRAF Firmware Update Tool.

Caution

- Requires Administrator access rights.
- Before you start the firmware version update program, close any other applications that are running.
- Do not try to use the printer while the firmware version update program is running. If a print job is executing, cancel the print job or wait for the job to finish before you execute the version update program.
- Never switch off the target printer while the firmware version update program is running.
- If you are unable to connect to the Internet to get the latest information, perform the following procedure.
1. Access the Canon website from a computer that can connect to the Internet and download the firmware corresponding to your printer.
2. Copy the downloaded firmware to the computer where this program is installed.
3. Run this program, select "Specify the Firmware", and specify the downloaded firmware.
- If the firmware version update fails while writing to the flash ROM, you may not be able to start the printer. In this case, contact a Canon service center or the dealer where you purchased the printer.

File information


File Name : ipffut-mac-25_02-ea8.dmg
File Type : FA
File Size : 572937KB