imagePROGRAF PRO-1000 Support
Drivers & downloads

Printer Firmware Updater (Mac) for the imagePROGRAF PRO-1000 Ver.2.4

Content Id: 0400252301


Description



Outline

This updater will upgrade your printer's firmware to version 2.070.
To perform this upgrade, a USB cable and a computer are needed.
If your printer's firmware version is already 2.070 or later, the update is not necessary.
To check your printer's firmware version, refer to the Update Procedure included in the downloaded file.

Detail

- Printer Update: The firmware to upgrade the functions of the printer.
- language’s folder: Contains the manual of the firmware update procedures. Launch it from fut_upgrade.html inside the language folder.

Update History

[Ver.2.4]
- Name of the tray at rear side has been changed.

[Ver.2.2]
- macOS Mojave (10.14) has been added as a supported OS.
- macOS High Sierra (10.13) has been added as a supported OS.
- Optimization of the specifications of Chroma Optimizer ink used in the auto maintenance.

[Ver.2.1]
- The following problem has been rectified.
Calibration from software is disabled.
- v10.11.6 and v10.12 has been added as a supported OS.

[Ver.2.0]
- "Head Replacement" menu is added on the operation panel menu.
- Some small failures are modified.

[Ver.1.1]
- ROM: The maximum printable height of custom paper size will be lengthened to 25.5-inch (647.70mm) with specifying in the printer driver.

[Ver.1.0]
- Cableless set-up failure on particular printers has been modified.
- Calculating formula of the necessary value for print cost aggregation with Accounting Manager has been revised.

System requirements

macOS Mojave 10.14
macOS High Sierra 10.13
macOS Sierra v10.12
OS X El Capitan v10.11.6
OS X Yosemite v10.10
OS X Mavericks v10.9
OS X Mountain Lion v10.8.5
OS X Lion v10.7.5

Setup Instructions

Double-click the downloaded dmg. file to decompress it. Then, open the newly-created "Printer Update" folder. And open the fut_upgrade.html inside the language’s folder, then execute the update of the firmware based on the manual "fut_upgrade.html".

Caution

- A USB cable & a computer are needed to perform this upgrade.
- See the attached manual to confirm the update procedures.
- Execute updating in the environment which you log onto as a member of the Administrators group.

File information


File Name : mfuu-mac-pro_1000-2_4-ea7.dmg
File Type : FA
File Size : 129815610KB