Drivers & downloads

ScanFront 400 System Software and Administration Tool

Content Id: 0400416822

Description

Outline

ScanFront 400 system software version 5.8.2412.2502, Administration Tool version 2.4.2024.801, OS version 1.6.12412.25001 and Web Service version 1.5.1.9
Administration tool software allows you to manage multiple ScanFront 400 scanners at a time. You can check the current status of the ScanFront scanners on the network, configure settings, manage users, back-up and restore configuration data.

Update History

V5.8
-Updated some OSS modules.
-Fixed an issue that caused an image file with a size of 0KB to be created when an image file with a size of 10 MB or more was sent using Scan to Shared Folder and the destination ran out of freespace.
-Fixed a problem where the "Mail" address was copied even if the check box was unchecked on the "Select Address > Shared/My Address Book > Specify and Confirm Copy Destination" screen.
-Bugs fix

V5.7
-Complied with the ERP regulations (NW Standby)
-Fix the issue where submission fails when shared folder name are specified with '$' prefix.
-Fixed the issue that ScanFront 400 v5.5 or later cannot send multiple files by FTPS (Explicit).
-Bugs fix

V5.5
-Support FTPS TLS session resumption.
(Fix the issue that the device can not send scanned data via FTPS to FileZilla Server version 1.6.7 or later.)
-Speed up 240dpi scanning (same speed or faster than 300dpi scanning)
-Change the condition for the execution of NTP synchronization, from when the gap is more than 3 mins to less than 30 seconds.
-Fix the JAM issue when users use carrier sheet with the short document.
It does NOT occur to every SF400, and has been already applied to mass production devices.
-Bugs fix

V5.4
-Support viewing with Microsoft Edge
-Bugs fix

V5.3
-Support Windows11
-Bugs fix

System requirements

-Windows Server 2016(64bit)
-Windows Server 2019(64bit)
-Windows Server 2022
-Windows 10(32bit/64bit)
-Windows 11

Setup Instructions

Step 1: Make sure that no one is using the scanner.
Step 2: Use the Canon ScanFront Administration Tool for SF400 and ensure that the [Status] shows [Connection Possible].
Step 3: Click the [Processing] Menu and select [Version Up...] then [Browse], and specify the update file you have downloaded.
Step 4: Click [Open].
Step 5: Confirm the message that appears, read, then click [OK] to perform the version update.
Step 6: Check that the correct version number is displayed, once the update has been completed.

If the firmware version displayed is not the updated version, please start again at step 1 to complete the procedure. If you are still experiencing any issues, please contact us for further assistance.

For further information on how to complete the firmware update procedure, please refer to Chapter 7 of the User Guide, which you can download by clicking on the Manuals tab.

Caution

-Do not power off during a version update.
-Make sure to back up your scanner data before performing a version update, using the ScanFront Administration Tool which you can download by clicking on the Software tab above.
-Do not operate the scanner until the scanner restarts after the version update is completed.
-Version upgrade may take longer when multiple addresses and job data are registered. Please wait and do not turn the power off while displaying that version upgrade is progressing.

File information

File Name : SF400_V.5.8_Firmware_V5.8.2412.2502_AdminTool_V2.4.2024.801.zip
File Type : FA
File Size : 440933289KB

Download